Information On Ink Cartridges And The Print Head - HP Photosmart C6200 All-in-One Série Guide D'utilisation

Chapter 4
To clear a paper jam from the Two-sided printing accessory
1. Turn off the HP All-in-One.
2. Press in the tabs on the left and right side of the Two-sided printing accessory. Remove the
accessory by pulling it away from the HP All-in-One.
CAUTION:
print mechanism. Always access and clear paper jams from the Two-sided printing
accessory of the HP All-in-One.
3. Gently pull the paper out of the rollers.
CAUTION:
and wheels for torn pieces of paper that might be remaining inside the device. If you do not
remove all the pieces of paper from the HP All-in-One, more paper jams are likely to occur.
4. If the paper jam is cleared, proceed to step 5.
If the paper jam is not cleared, do the following:
a. Open the Two-sided printing accessory by pulling the tabs up.
b. Remove any paper from inside the accessory.
c. Close the Two-sided printing accessory by pressing the tabs down until they lock into place.
5. Replace the Two-sided printing accessory. Gently push the accessory forward until it snaps into
place.
6. Turn on the HP All-in-One, and then press OK to continue the current job.

Information on ink cartridges and the print head

The following tips help maintain HP ink cartridges and ensure consistent print quality.
• Install the ink cartridge on or before the install by date, which is printed on the ink cartridge
package.
• Keep all ink cartridges in the original sealed packages until they are needed.
• Turn off the HP All-in-One by pressing the On button located on the device. Do not turn off the
device by turning off a power strip or unplugging the power cord from the HP All-in-One. If you
improperly turn off the HP All-in-One, the print head assembly might not return to the correct
position.
• Store ink cartridges at room temperature (15.6°-26.6° C or 60°-78° F).
• HP recommends that you do not remove the ink cartridges from the HP All-in-One until you have
replacement cartridges available to install.
If you are transporting the HP All-in-One make sure you turn off the device by pressing the
On button to power it down properly. Also, make sure you leave the ink cartridges installed.
Doing these actions will prevent ink leaking from the print head assembly.
• Clean the print head when you notice a significant decrease in print quality.
• Do not clean the print head unnecessarily. This wastes ink and shortens the life of the cartridges.
• Handle ink cartridges carefully. Dropping, jarring, or rough handling during installation can cause
temporary printing problems.
30 HP Photosmart C6200 All-in-One series
Trying to clear a paper jam from the front of the HP All-in-One can damage the
If the paper tears when you are removing it from the rollers, check the rollers