Network Setup; Set Up The Hp All-In-One On An Integrated Wireless (Wlan 802.11) Network - HP Photosmart C4500 All-in-One Série Guide D'utilisation

1

Network setup

This section describes how to connect the HP All-in-One to a network and how to view
and manage network settings.
If you want to:
Connect to a wireless network with a wireless
router (infrastructure).
Connect directly to a wireless-capable
computer without a wireless router (ad-hoc).
Add connections to more computers on the
network.
Change the HP All-in-One from a USB
connection to a network connection.
NOTE: Use the instructions in this section if
you first installed the HP All-in-One with a USB
connection, and you now want to change to a
wireless network connection.
View or change the network settings.
Find troubleshooting information.
Set up the HP All-in-One on an integrated wireless (WLAN
802.11) network
The HP All-in-One uses an internal networking component that supports a wireless
network.
For optimal performance and security in your wireless network, HP recommends you use
a wireless router or access point (802.11) to connect the product and the other network
elements. When network elements are connected through a wireless router or access
point, this is called an infrastructure network.
2 HP Photosmart C4500 All-in-One series
See this section:
"Set up the HP All-in-One on an integrated
wireless (WLAN 802.11) network"
on page 2
"Connect to a wireless ad hoc network"
on page 6
"Connect to additional computers on a
network" on page 7
"Change the HP All-in-One from a USB
connection to a network connection"
on page 7
"Manage your network settings" on page 9
"Network troubleshooting" on page 23