Installation Steps - AVS Ventvisor Deflector Instructions D'installation

Installation Steps

Roll down window. Buff the inside felt surface
with scotch brite pad. Then clean with alcohol
clean
1
Apply one coat of surface prep to rubber trim.
Prep rubber trim on both sides before install-
3
NOTE: See warning on page 1 regarding surface prep
Press the exposed area of tape against the surface and
verify position.
5
Apply pressure along the inside of window channel and
flange edges to secure in place.
7
NOTE: Actual application may vary slightly from illustrations.
pad.
inside of vehicle
ing visors.
Remove the tape from the rear flanges. Peel back 2"
(5cm) of tape liner from each end of top flange.
free end
2
Insert visor into window channel, front flange first, then
slide flange between
rubber and mirror cap
4
With the visor in its final position, remove the remain-
der of the tape liner by pulling on free ends.
6
Roll up window and leave window up for 24 hours to
ensure proper adhesion.
12
9 3
6
8
Page 2 of 3
free end
rear end flange
front end flange
seat rear flange.
front end
flange
free end