Quick Guide; To View The Playback Picture - Panasonic Palmcorder MultiCam PV-VM202 Mode D'emploi

1
POWER CHARGE
QUICK 100%
1
2
3
4
4
3
OPEN/EJECT
5
CAMERA
VCR
CARD P. B.
6, 7
OFF ON MODE
CAMERA
VCR
CARD P. B.
POWER
6

Quick Guide

1
Charge the Battery.
≥Connect the AC Cable to the AC Adaptor and plug it into Wall Outlet.
≥Attach the Battery to the AC Adaptor. (This will start the charging
process.)
≥After the [POWER] Lamp has lit up, the [CHARGE] Lamp flashes.
When the [100%] Lamp
≥Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
2
Attach the Charged Battery to the Palmcorder.
MODE
OFF ON
CAMERA
VCR
CARD P. B.
POWER
2
3
Turn the Palmcorder on.
≥Slide the
4
Insert the Cassette.
≥Slide the [OPEN/EJECT]
Cassette compartment cover completely.
≥Insert the Cassette.
≥Press the [PUSH TO CLOSE]
≥Close the lower compartment Cover.
5
Start recording.
≥Press the
≥Press the
MODE
OFF ON
POWER
5

To View the Playback Picture

6
Switch to the VCR Mode, rewind the tape, and play the tape
back.
≥Set the
≥Press the
≥Press the
≥Press the
8
7
BACKLIGHT
Turn the Palmcorder off.
≥Set the
CAMERA
STILL
9
7
(l 12)
1
on the AC Adaptor is lit, charging is finished.
(l 14)
2
Switch to [ON]. (The [CAMERA] Lamp lights up.)
(l 13)
3
lever to the right and pull down to open the
4
(l 20)
5
Button. (Recording starts.)
5
Button again to pause the recording.
(l 28)
6
Switch to VCR mode. (The [VCR] Lamp lights up.)
7
Button. (Rewind the tape.)
8
Button. (Playback starts.)
9
Button. (Playback stops.)
(l 14
6
Switch to [OFF].
(l 12)
to load the Cassette.
)
7