Digital Zoom Function; Digital Electronic Image Stabilizer Function; Fade In/Out Functions - Panasonic Palmcorder MultiCam PV-VM202 Mode D'emploi

20t W
D.ZOOM
1
22

Digital Zoom Function

This function is useful when you want to record close-up shots of subjects
W.B./SHUTTER/IRIS/
1
MF/VOL/JOG
located beyond a normal zoom range of 1k to 10k magnification. With the
2 1
PUSH
Digital Zoom Function, you can select a magnification of 25k or 200k.
1
1
Set [CAMERA FUNCTIONS] >> [CAMERA SETUP] >>
[D.ZOOM] >> [25
2
≥25k: Digital zooming to 25k
W
3 ≥200k: Digital zooming to 200k
4
2
To zoom in or out, press the [W/T] zoom lever towards [T] or
T
towards [W].
≥As the magnification of digital zooming increases, the quality of image may
deteriorate.
Canceling the Digital Zoom Function
Set [D.ZOOM] on the [CAMERA SETUP] Sub-menu to [OFF].
T
≥For other notes, see page 60.
~~~~~~~~~~~~~~~~~~~~~~~~

Digital Electronic Image Stabilizer Function

If you are recording in unstable situations and the Palmcorder is shaky, you
can use this function to correct for camera shake in these images.
≥If the Palmcorder shakes too much, this Function may not be able to
stabilize images.
1
EIS
1
Set [CAMERA FUNCTIONS] >> [CAMERA SETUP] >> [EIS] >>
[ON].
≥The [EIS] Indication
Canceling Digital Electronic Image Stabilizer
Set [EIS] on the [CAMERA SETUP] Sub-Menu to [OFF].
W.B./SHUTTER/IRIS/
MF/VOL/JOG
2 1
EIS function may not work when...
PUSH
≥Palmcorder movement is too extreme.
1
≥Recording a subject with distinct horizontal or vertical stripes.
≥Recording in low light situations.
≥Recording a subject under a great amount of fluorescent light.
≥Recording a scene with very fast movement.
≥For other notes, see page 60.
~~~~~~~~~~~~~~~~~~~~~~~~

Fade In/Out Functions

Fade In
Fade In brings out images and sounds gradually from a black screen at the
beginning of a scene.
1
Hold down the [FADE] Button while the Palmcorder is set to
the Recording Pause Mode.
≥The image fades out gradually.
2
When the image is completely gone, press the Recording
Start/Stop Button to start recording.
3
Release the [FADE] Button about 3 seconds after starting
recording.
≥The image reappears gradually.
2
Fade Out
Fade Out causes images and sounds to disappear gradually, leaving a black
screen at the end of a scene.
1, 3
1
Hold down the [FADE] Button while recording.
≥The image fades out gradually.
2
About 3 seconds after the image is completely gone, press
the recording Start/Stop Button to stop recording.
2
3
Release the [FADE] Button.
≥Fade in/out function cannot be used in MPEG4 Recording Mode (l 38),
PhotoShot Recording Mode, or Still Picture Mode (l 21).
≥For other notes, see page 60.
t t t t ] or [200
1
appears.
1
2
t t t t ]