Continuous Measurement - Bosch 3.011 Instructions D'emploi

In the "DIAGNOSIS" menu, you have the choice of two types of
measurement: "CONTINUOUS MEASUREMENT" and "FREE
ACCELERATION".
Use the cursor keys z z z z and v z
confirm it by pressing ENT.

4.1 Continuous measurement

Procedure:
- Connect the engine-speed sensor to the vehicle.
- Start the engine and if necessary warm it up.
- Insert the exhaust-gas probe into the exhaust pipe and make
sure it is seated securely.
Caution! Hot probe!
The exhaust-gas probe may still be very hot from being
used beforehand for testing a different vehicle.
You then select the number of pulses and cylinders (proceed
as described in the passage "Selecting the number of pulses
and cylinders" in section 3.3 "Engine preconditioning and
prechecks").
The current engine speed (RPM) is also displayed at the same
time.
After selecting, confirm the inputs by pressing ENT.
You can now carry out up to 25 measurement rev-ups at different
engine speeds (RPM).
Once the engine has reached the desired speed, press the # key
to store the measured value. The measurement is then stopped
by pressing ESC.
z z z and v
Using the cursor keys z z
the measured values or end continuous measurement completely.
Confirm your selection by pressing ENT.
4.2 Free acceleration
This procedure is used to measure the exhaust-gas values, e.g.
when adjusting the engine. The k values are not evaluated and no
purging rev-ups are carried out.
A maximum of 10 measurement rev-ups can be carried out.
If you want to stop carrying out measurement rev-ups before you
reach 10 times, press ESC or ignore the "FULL THROTTLE"
prompt (i.e. do not rev up the engine); the program will then detect
time-out after a specified delay has elapsed.
At the end of the measurements, you can use the cursor keys
z and v z z z z v v v v to display or print out the measured values, print out
curves which show the opacity and engine-speed values plotted
against time, or end this type of measurement completely.
Confirm your selection by pressing ENT.
38
v to make your selection and v v v
v , you can then display or print out v v
v