Honsel S-416 Plus Manuel D'utilisation page 58

Problem
Within the operating mode
Non-Conductive Materials,
the machine behaves in
the same way as in the
operating mode Conductive
Materials mode. Pressure
is built.
Automatic feed system:
The automatic feed system
does not react.
Automatic feed system:
Self-clinching fastener
enters the separation
module but does not reach
the tool.
Automatic feed system:
The vibration of the feed
tank is very loud.
Self-clinching fasteners are
thrown out of the feed tank.
Automatic feed system:
Self-clinching fasteners do
not get into the orientation
module.
58 | English
Possible cause
Electronics are defective.
Automatic feed system is not
switched on.
Automatic feed system is not
connected or is incorrectly
connected to the machine.
Electronics are defective.
Air pressure is too low.
Air-eject-time is too low.
The orientation module and the
separation module touch each
other.
The fixing screw in the middle of
the feed tank is loose.
Feed-rate is too high.
Feed-rate is too low.
The set periodic feed-mode is
not sufficient to transport the
self-clinching fasteners into the
orientation module.
Remedy
Contact the VVG service.
Press Switch On/Off.
Contact the VVG service.
Contact the VVG service.
Make sure that the set air pressure is
0.6 MPa, see chapter 3.11.2.
Increase Air-eject-time, see chapter
3.11.2.
Unscrew both modules and
re-screw them so that there is a
gap of approximately 0.5 cm (0.2 in)
between the modules.
Tighten the screw to 100 Nm with a
torque wrench.
Reduce feed-rate, see chapter
3.11.2.
Increase feed-rate, see chapter
3.11.2.
Set feed-mode to permanent, see
chapter 3.11.2.