Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
No .
Designation
4
Feed controller
5
Operating unit, see chapter 2.4.9.2
6
Indicator Air Pressure in MPa
7
Feed tank
2 .4 .9 .2 Indicators and operating elements
The indicators and operating elements of the feed
system are located on the operating unit of the feed
system, see chapter 2.4.9.1.
14
13
12
11
Figure 9
Operating unit feed system
No .
Designation
1
Indicator Air Pressure
Scale in MPa
Default setting: 0.6 MPa
2
Rotary Knob Feed-Rate
Scale in cps = cycles per second
3
Toggle Switch Feed-Mode
Default setting: Continuous Feed-Mode
4
Position Continuous Feed-Mode
5
Position Periodic Feed-Mode
6
Rotary Knob Air-Eject-Time
Scale in s
Default setting: 2 s
7
Fuse
8
Switch On/Off
40 | English
1
2
3
4
5
10
9
8
7
No .
Designation
9
LED On
10
Switch Manual Feeding
11
Connection Compressed Air
12
Position Maximum Value
13
Position Minimum Value
14
Rotary Knob Air Pressure
2 .4 .10 Tool protection system (optional)
The tool protection system protects the tool and
the workpiece from damage. The tool protection
system detects when the application of force is
imminent. If the tool is not exactly in the position
previously set for the machine before applying the
force, the pressing-in process will not be carried
out. In this case the upper tool moves back.
6
Figure 10
Tool protection system
No .
Designation
1
Controller
2
Position Indicator in inch
3
Toggle Switch On/Off
4
Tool Contact Lamp
5
Position Indicator in mm
1
5
2
4
3
Publicité
Chapitres
Table des Matières
