Default Setting - Honsel S-416 Plus Manuel D'utilisation

Special tools are needed to use
the automatic feed system, please
contact the HONSEL service for
further information.
Value
Feed-Mode
Feed-Rate
Air pressure
Air-Eject-Time
HONSEL recommends choosing
the default settings for the first test.
Precondition:
• The optional fixed stop system is mounted on
the machine.
• The machine is set up, see chapter 3.7 or 3.8
• The desired tool is installed in both tool
holders.
• The feed tank is filled, see chapter 3.11.1.
1. If a self-clinching fastener of a different
type was previously used, then unscrew the
orientation module and separation module and
remove all self-clinching fasteners from both
modules.
2. Press the Switch On/Off on the operating unit
of the automatic feed system, see chapter
2.4.9.2.
LED On on the operating unit of the
»
automatic feed system lights green.
3. Use the Toggle Switch Feed-Mode on the
operating unit of the automatic feed system
to set the feed tank to continuous or periodic
vibration, see Figure 8.
(Default setting: continuous feed-mode)
4. Use the Rotary Knob Feed-Rate on the
operating unit of the automatic feed system
unit to adjust the oscillations per second of the
feed tank.
There is no default setting for the
feed-rate. The optimum setting
for the respective self-clinching
fastener must be found out by
testing. The heavier the self-clinch-
ing fastener, the higher the optimal
feed-rate.
50 | English

Default setting

Permanent
-
0,6 MPa
2 s
5. To adjust the air pressure, pull out the Rotary
Knob Air Pressure on the operating unit control
of the automatic feed system and turn it until
the Indicator Air Pressure shows the desired
value.
(Default setting: 0.6 MPa)
6. Set the Rotary Knob Air-Eject-Time on the
operating unit of the automatic feed system to
the desired time.
(Default setting: 2 s)
7. Set the Selection Switch Operation/Setup on
the insertion machine to Operation.
8. Insert the associated key into the Key Switch
Operating Mode at the insertion machine.
9. For workpieces made of conductive materials,
turn the Key Switch Operating Mode on the
insertion machine with the key to Conductive
Materials.
Or
For workpieces made of non-conductive
materials, turn the Key Switch Operating
Mode on the insertion machine with the key to
Non-Conductive Materials.
10. Place the workpiece on the lower tool so that
the hole is approximately in the middle of the
lower tool.
11. Use Switch Manual Feeding on the operating
unit of the automatic feed system to transport
the self-clinching fastener to the tool.
The self-clinching fastener is on the tool.
»
12. Keep hands away from both tool holders.
13. For workpieces made of conductive materials,
perform step 5 to 7 according to chapter 4.7.
Or
For workpieces made of non-conductive
materials, perform step 5 to 8 according to
chapter 4.8.
Automatic feed system is set up.
»
4 Operation
WARNING
Improper operation of footswitch
Death, serious injury or material
damage
• Do not hold the foot permanent-
ly on the footswitch.
• Do not move the foot to the
footswitch as long as there are
body parts or foreign objects
between the tool holders.
• Remove foot from footswitch
after pressing footswitch.