Press-In With Automatic Feed System - Non-Conductive Materials; Maintenance; Maintenance Plan; Change Filter Hydraulic Oil - Honsel S-416 Plus Manuel D'utilisation

6. Inspect result of the pressing-in process.
7. If the result is not adequate, start setup again.
4 .8 PRESS-IN WITH AUTOMATIC FEED
SYSTEM - NON-CONDUCTIVE MATERIALS
Precondition:
• The machine is switched on, see chapter 4.1.
• The workpiece has a hole for the self-clinching
fastener.
• The function of safety system was tested
successfully, see chapter 3.3.
• The machine is set up, see chapter 3.8.
• The desired tool is installed in both tool
holders.
1. Switch on the automatic feed system with the
Switch On/Off on the operating unit of the
automatic feed system, see chapter 2.4.9.2.
LED On on the operating unit of the
»
automatic feed system lights green.
2. Set up automatic feed system, see chapter
3.11.
3. Perform step 1 to 4 according to chapter 4.6.
4. Keep hands away from both tool holders.
5. Press and hold the Down Footswitch.
The upper tool holder moves down and
»
stops in front of the self-clinching fastener.
6. Press again the Down Footswitch until the
upper tool touches the self-clinching fastener.
The pressing-in process starts.
»
When the press-in time is over, the upper
»
tool holder returns to its starting position.
7. Inspect result of the pressing-in process.
8. If the result is not adequate, start setup again.

5 Maintenance

5 .1 MAINTENANCE PLAN

Without the described maintenance, a trouble-free
operation of the machine is not guaranteed.
Task
Test safety system,
see chapter 3.3.
Lubricate cylinder on
upper tool holder with
lithium grease.
Change filter hydraulic
oil, see chapter 5.2.

Change hydraulic oil,

chapter 5.3.
54 | English
Frequency
Before every start of
work
Monthly
Annual
Every 2 years

5 .2 CHANGE FILTER HYDRAULIC OIL

Figure 13 Change filter
No . Designation
1 Filter unit
2 Filter
The location of the filter unit is
described in chapter 2.4.4.
The filter can be ordered via
HONSEL service.
Precondition:
• The machine is switched off.
1. Loosen the screws on the right engine cover.
2. Remove right engine cover.
3. Loosen the screws of the filter unit.
4. Put on some protective gloves.
5. Remove the filter unit.
6. Unscrew the filter from the filter unit.
7. Screw new filter onto the filter unit.
8. Insert filter unit.
9. Take off the protective gloves.
10. Screw tight the filter unit.
11. Screw tight the right engine cover.
5 .3 CHANGE HYDRAULIC OIL
The location of the hydraulic oil tank
is described in chapter 2.4.4.
Precondition:
• The machine is switched off.
• The media supply is connected.
1
2