Tool Holder; Fixed Stop System (Optional) - Honsel S-416 Plus Manuel D'utilisation

2 .4 .5 Tool holder

1
2
3
4
5
6
Figure 5 Tool holder
No . Designation
1 Cylinder
2 Clamp screw
3 Upper tool holder
4 Tool adapter
5 Upper tool
6 Lower tool holder
7 Lower tool
8 Quick change tool
Contact the HONSEL service for
information on optional tool holders
and other accessories.
38 | English

2 .4 .6 Fixed stop system (optional)

With the fixed stop system, the upper tool holder
always returns to the same position.
7
8
Figure 6
No . Designation
1 Nut tube
2 Stop tube
3 Clamp screw
Warning
Exceeding the allowed force for
tool holder J-frame
Minor injury or material damage
• When using the J-frame,
never exceed the maximum
allowed press-in force of 40 kN
(9000 lb).
• Remove the J-frame before
using a press-in force greater
than 40 kN (9000 lb).
Fixed stop system
Contact the HONSEL service for
further information.
1
2
3