Compressor Accessory; Mortar Hose For Pneumatic Spray Lance; Mortar Hose For Automatic Spray Lance; Spray Lance - Titan PowrPlast 1000 Mode D'emploi

GB
OVERVIEW
4.3

COMPRESSOR ACCESSORY

VKM 592 intake volume 590 l/min
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
4.4

MORTAR HOSE FOR PNEUMATIC SPRAY LANCE

1 Material connection mortar spraying machine
2 Atomizing air connection compressed air supply
3 Material connection spray lance
4 Mortar hose
5 Atomizing air connection spray lance
1
5 4
34
2
3
4.5

MORTAR HOSE FOR AUTOMATIC SPRAY LANCE

1 Material connection mortar spraying machine
2 Control cable connection / controller
3 Atomizing air connection compressed air supply
4 Material connection spray lance
5 Mortar hose
6 Atomizing air connection spray lance
7 Control cable connection/ automatic spray lance
2
1
7 6
4.6

SPRAY LANCE

1 Material connection
2 Combined material and air tap:
Open: material tap at 90° to spray lance
Closed: material tap points forwards
3 Texture tip:
Various texture tips can be used in the spray lance. The tip
size depends on the granular size of the coating material
and the desired spray pattern.
4 Hand-grip:
The hand-grip can mounted to either the right or left side
of the spray lance, depending on what is required. The
thread on the other side can be closed by way of the at-
tached stoppers for protection.
5 Control cable connection (automatic version only)
6 Air ow regulator
7 Atomization air connection
6
7
5
PowrPlast 1000
3
5 4
2
1
4
3