FAR LV13C37G21IX Manuel D'utilisation page 141

All manuals and user guides at all-guides.com
Problem
Improper detergent
Suds in the tub
Spilled rinse agent
Stained tub Detergent with colorant
interior was used
Dishes and
Improper program
flatware not
Improper basket loading
clean
1 Extremely hard water
2 Low inlet temperature
3 Overloading the
dishwasher
Spots and
4 Improper loading
filming on
5 Old or damp powder
glasses and
detergent
flatware
6 Empty rinse agent
dispenser
7 Incorrect dosage of
detergent
Cloudiness on Combination of soft water
glassware and too much detergent
Possible Causes What To Do
Use only the special dishwasher
detergent to avoid suds. If this
occurs, open the dishwasher and
let suds evaporate. Add 1 gallon
of cold water to the tub. Close and
latch the dishwasher, then start the
"pre-rinse" wash cycle to drain out
the water... Repeat if necessary.
Always wipe up rinse agent spills
immediately.
Make sure that the detergent is the
one without colorant.
Select a stronger programme.
Make sure that the action of the
detergent dispenser and spray arms
are not blocked by large dishware.
To remove spots from glassware:
1 Take out all metal utensils out of
the dishwasher.
2 Do not add detergent.
3 Choose the longest cycle.
4 Start the dishwasher and allow it
to run for about 18 to 22 minutes,
then it will be in the main wash.
5 Open the door to pour 2 cups of
white vinegar into the bottom of
the dishwasher.
6 Close the door and let the
dishwasher complete the cycle.
If the vinegar does not work:
Repeat as above, except use 1/4
cup (60 ml)of citric acid crystals
instead of vinegar.
Use less detergent if you have soft
water and select a shortest cycle to
wash the glassware and to get them
clean.
ENGLISH
GB-64