Operating Procedure; Charge Vehicle - Bosch EV3000 Guide D'utilisation

10.6 Fault Status Codes
The status code screen displays codes used to
identify points of fault.
Fig. 18: Page showing faults detected during charge
Fig. 19: Page showing list of fault codes after charge
is complete
Fig. 20: Page directing user to press manual stop
button
Fig. 21: Service required screen with fault codes
© Bosch Automotive Service Solutions Inc.
Operating Procedure | EV 3000 | 13

11. Operating Procedure

11.1 Initialize System
¶
Engage the power switch to the On position, if
the EV 3000 is not already powered on.
"
The home page will appear when the
EV 3000 is ready for use.
11.2 Connect Charging Connector
Remove charging connector from charging
1.
connector holder.
Plug charging connector into electric vehi-
2.
cle charging inlet.
i
The EV 3000 will automatically detect the
charging connector type.
i
To terminate session before charging, press
the left button to return to the home page.
11.3

Charge Vehicle

Charging will begin automatically, after the
1.
charging connector is plugged in to the
electric vehicle charging port.
"
When charging is complete, the EV 3000
will automatically: stop charging, display
charging summary page (see Fig. 19), and
unlock the charging connector.
11.4 End Charging
Press stop button to end incomplete charge.
1.
Disconnect the charging connector from
2.
the electric vehicle inlet.
Review charging summary.
3.
11.5 Check Status Messages
¶
Match any displayed status codes to the
provided list, to determine the source(s) of
problems detected while charging.
i
Troubleshooting instruction can be found by
matching the status code to the Troubleshoot-
ing table.
12. Troubleshooting
This section is intended to help you get back
on track if the EV 3000 appears to be operating
abnormally. If the error is not eliminated by the
indicated remedy, it is necessary to contact
Service.
|
VER.00 SP0 150 2139
en