Operating Instructions; Power And Status Led Indications - Bosch Power Xpress Instructions D'installation Et D'utilisation

Operating Instructions

1. Verify service supply power is available; green POW-
ER indicator LED is illuminated.
2. Retrieve Charge Station vehicle cable and coupler
from rear-mounted holder (stowed position); amber
STATUS indicator light is illuminated.
3. Connect Charge Station coupler to vehicle; STATUS
indicator LED changes to solid green.
4. Charge Station performs safety self-test (audible
mechanical clicking sounds); STATUS indicator
begins to flash green, indicating vehicle is charging
(vehicle may indicate charging with an audible
signal or a light indicator; varies by vehicle model).
When charge is complete, the STATUS LED will
change from flashing green to solid green.
5. Disconnect Charge Station coupler from vehicle;
STATUS indicator changes to amber.
6. Return cable and coupler to rear-mounted holder
(stowed position) at Charge Station unit.
Note:
Charge Station will automatically resume charging upon
restoration of lost service-supply power (US models
only).
Bosch Automotive Service Solutions Inc.
Installation and Operating Instructions | Power Xpress Charge Station | 19 | en

Power and Status LED Indications

Power LED
(Off)
Green
solid
Green
solid
Green
solid
Green
solid
Green
solid
Green
solid
Green
solid
Green
solid
*See "Troubleshooting" on page 20 for suggested
solutions.
Status LED Condition
No service supply
(Off)
power
Charge Station
powered; vehicle
Amber solid
coupler not
connected
Green solid Waiting to charge
Green
Vehicle charging
flashing
1–2 red
flashes Pilot charging
every 2 error*
seconds
Solid red,
then green Ground fault
flash every detected*
2 seconds
Red Ground monitor
flashing interrupted*
Red solid Operation fault*
(Off) Operation fault*
- No illumination
- Solid illumination
- Flashing illumination
578987 | REV. A | 15.06.2016