Bosch Power Xpress Instructions D'installation Et D'utilisation page 16

en | 1 4 | Installation and Operating Instructions | Power Xpress Charge Station
Note:
To avoid damage to the Charge Station, place it on a
soft or cardboard surface.
10. Locate the desired conduit-entry point on the
Charge Station housing.
ss01455
11. Drill a pilot hole in the center of the selected knock-
out location.
12. Using a 1 5/16-in. (33-mm) hole saw, with the pilot
hole as a guide, drill out the knockout.
CAUTION: Use a mid-range speed setting
and drill carefully to avoid punching
through housing and damaging internal
components.
13. Remove debris from wiring chamber.
14. Install a 1-in. (25.4-mm) NPT female adaptor with
nut and seal into the knockout and tighten securely.
578987 | REV. A | 15.06.2016
ss01430
ss01431
15. Secure the Charge Station to the mounted wall
bracket by engaging the tabs on the Charge Station
into the slots on the wall bracket. Press firmly and
slide the Charge Station down until fully seated on
the bracket.
ss01459
16. Feed the wire from the service panel through the
conduit and into the Charge Station wiring chamber.
17. Attach offset conduit to NPT female adaptor.
ss01429
18. Remove the strain-relief assembly from the wiring
chamber.
19. Trim the wire to a length sufficient to make the con-
nections to the Charge Station terminal block.
20. Strip back 1 1/4 in. (32 mm) of the wire jacket and 3/8
in. (10 mm) from the ends of the individual conductors.
L2/N
Bosch Automotive Service Solutions Inc.