Masonry Wall Charge Station Installation - Bosch Power Xpress Instructions D'installation Et D'utilisation

Masonry Wall Charge Station Installation

1. Locate and mark a point 45 in. (114.3 cm) above
the floor surface.
ss01448
2. From this point, use a level to draw a true vertical
line and a true horizontal line on the wall.
3. Retrieve the mounting template on the back cover
of this manual.
ss01412
4. Align the hash-marked center and lower horizontal
lines of the template to the lines drawn on the wall.
Adhere the template to the wall with tape.
Bosch Automotive Service Solutions Inc.
Installation and Operating Instructions | Power Xpress Charge Station | 13 | en
ss01451
ss01453
5. Using a 1/8-in. (3-mm) drill bit, drill the three (3)
holes marked "A" on the template.
6. Select a location on the template for entry of conduit
into the Charge Station (top, upper left, or upper right).
7. Snap a chalk line from the appropriate level line on the
template in the direction of the incoming conduit.
8. Remove the template from the wall.
ss01454
9. Align the mounting plate with the "A" holes in the
wall and secure with three (3) 3/16-in. (5-mm) ta-
pered-head masonry screws.
578987 | REV. A | 15.06.2016