Bosch Power Xpress Instructions D'installation Et D'utilisation page 13

14. Cover the plastic bushing with the self=adhesive
foam dust-cover gasket, with the center-slit oriented
ss01425
horizontally.
15. For outdoor installation, assemble the rubber
grommet into the knockout and snap into place.
16. Feed the wire from the service panel, through the
dust cover or grommet, and into the Charge Station
wiring chamber.
ss01426
17. Secure the Charge Station to the mounted wall brack-
et by engaging the tabs on the Charge Station into the
slots on the wall bracket. Press firmly and slide the
Charge Station down until fully seated on the bracket.
Bosch Automotive Service Solutions Inc.
Installation and Operating Instructions | Power Xpress Charge Station | 11 | en
ss01430
ss01431
ss01432
ss01429
18. Remove the strain-relief assembly from the wiring
chamber.
19. Trim the wire to a length sufficient to make the con-
nections to the Charge Station terminal block.
20. Strip back 1 1/4 in. (32 mm) of the wire jacket and
3/8 in. (10 mm) from the ends of the individual
conductors.
21. Remove threaded ground lug.
L2/N
L2/N
578987 | REV. A | 15.06.2016