Molded Plug-Connected Charge Station Installation (North America Only) - Bosch Power Xpress Instructions D'installation Et D'utilisation

en | 1 6 | Installation and Operating Instructions | Power Xpress Charge Station
Molded Plug-Connected Charge Station
Installation
(North America only)
ss01478
1. Install appropriate outlet box (ground-pin at
12-o'clock position) with top- or side-conduit feed.
CAUTION: Do not feed the outlet box from
the bottom. This will interfere with the
mounting of the Charge Station unit.
2. Place the outlet box between two (2) studs for
finished-wall installation or any applicable location
for masonry walls.
3. Install outlet box 61 in. (155 cm) from floor surface
to the bottom of the outlet box.
ss01474
4. Locate and mark a point 16 in. (40.6 cm) down
from the bottom-center of the outlet box.
5. From this point, use a level to draw a true vertical
line and a true horizontal line on the wall.
6. Retrieve the mounting template on the back cover
of this manual.
578987 | REV. A | 15.06.2016
7. Align the hash-marked center and lower horizontal
lines of the template to the lines drawn on the wall.
Adhere the template to the wall with tape.
8. If installing on a masonry wall, using a 1/8-in. (3-mm)
drill bit, drill the three (3) holes marked "A" on the
template.
9. If installing on a finished wall, using a 3/16-in. (5-
mm) drill bit, drill the six (6) holes marked "B" on
the template.
10. Remove the template from the wall.
11. Align the mounting plate with the holes in the wall
and secure with three (3) 3/16-in. (5-mm) tapered-
head masonry screws for masonry walls or six (6) #8
pan-head screws with anchors for finished walls.
Note:
To avoid damage to the Charge Station, place it on a soft
or cardboard surface.
12. Locate the desired conduit-entry point on the Charge
Station housing.
ss01455
13. Drill a pilot hole in the center of the selected knock-
out location.
Bosch Automotive Service Solutions Inc.