7.5 Finished Wall Installation
WARNING: Read all instructions before installing the EV400 .
The EV400 must be mounted to the studs of a drywall/wood-stud structure, or to a masonry-wall. For a drywall/wood-stud
structure the EV400 is specifically designed to be secured to the studs. This is the reason the two mounting slots are
designed into the EV400's back mounting surface in a centered, vertical in-line configuration (not unlike that of a standard
multi-plug power-strip).
1.
Using a stud finder, locate the desired mounting points for the EV400's two (2) mounting screws (denoted on the
template with the symbols), and draw a vertical line to mark the stud site.
2.
Using adhesive tape, secure the mounting template (included on page 18 of this manual) to the desired mounting
location wall surface. Mount the template at a height of 45" from the floor to the bottom of the template.
Installation and Operating Instructions | Bosch™ EV400 Series Charging Station | 13 | en
REV E | 02.19.2019