Introduction; Important Safety Warnings And Cautions - Bosch EV400 Serie Guide D'installation/Mode D'emploi

1

Introduction

The EV400 Charging Station is designed for the North
American, European, Japanese, and other markets to
charge plug-in electric vehicles (PHEV) and battery electric
vehicles (BEV).
This document provides instructions for the EV400 Charging
Station and is not for use for any other product. Before
installation or use of this product, you should review this
manual carefully and consult with a licensed contractor,
licensed electrician, or trained installation expert to ensure
compliance with building codes and safety standards.
2 Important Safety Warnings
and Cautions
Please read and follow these safety Warnings and Cautions
carefully before operating the EV400 Charging Station.
Failure to follow these instructions may result in serious
injury or property damage.
SAVE THESE INSTRUCTIONS!
WARNINGS
} When using electrical products, basic precautions
should always be followed, including the following .
This manual contains important instructions for
models EL-52503-XXX that shall be followed during
installation, operation, and maintenance of the unit .
} Read all the instructions before using this product .
} Children should be supervised when this product is
used around children .
} Do not put fingers into the EV connector.
} Do not install the EV400 near flammable, explosive, or
combustible materials . Do not locate or store
flammable, explosive, or combustible materials near
the EV400 .
} Do not use this product if the flexible power cord or
EV cable are frayed, have broken insulation, or display
any other signs of damage .
} Do not use this product if the enclosure or the EV
connector is broken, cracked, open, or show any other
signs of damage .
} The EV400 contains no user-serviceable parts . Do not
attempt to open, repair, or service the EV400 yourself .
Do not attempt access to the internal components of
the EV400 unit in any way . Do not tamper with any of
the product labeling and/or the clear back overlay
that is meant for Bosch technical maintenance
personnel only . If the EV400 requires servicing,
contact Bosch .
} Disconnect main service power to the EV400 before
cleaning the unit . Do not use cleaning solvents to
clean any part of the EV400 . Clean enclosure, cable,
and connector with a clean, dry cloth to remove dust
and dirt accumulation .
Installation and Operating Instructions | Bosch™ EV400 Series Charging Station | 5 | en
} Disconnect main service supply or unplug unit to
achieve electrical isolation .
} If the EV400 fails to operate correctly in accordance
with the operation manual, do not use this device .
Contact Bosch for repair or replacement .
} Improper installation of the EV400 can result in
personal injury or product damage .
} This EV400 installation guide is not a substitute for
electrical safety precautions .
} Use this EV400 within the specified operating
parameters . Failure to do so may result in injury or
death .
} Locate and install this EV400 in a location where the
charge cable will not be stepped on, tripped over, or
subject to damage or stress .
} The EV400 must be connected to a grounded, metal,
permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal on the
EV400 .
} DO NOT USE AN EXTENSION CORD ON THE EV400 .
This can cause a shorting or over-heating condition
that could lead to injury or death .
} Incorrect installation of the EV400 can result in damage
to the vehicle's battery and to the EV400 itself. These
damages will void the warranty for the vehicle and the
EV400.
} Do not operate the EV400 in temperatures beyond its
operating range of -31°F to +122°F (-35°C to +50°C).
CAUTIONS
REV E | 02.19.2019