Power Supply Cable Check; Squeegee Cleaning - Nilfisk CA 551 Manuel D'utilisation

USER MANUAL

POWER SUPPLY CABLE CHECK

1. Carefully check the power supply cable and the relevant plug for wear, cuts, cracks or other damages.
If the power supply cable or the relevant plug is damaged, contact the Nilfisk-Advance Service Center before using the
machine again.

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
CAUTION!
It is advisable to use protective gloves when cleaning the squeegee because there may be sharp debris.
1. Drive the machine on a level floor.
2. Disconnect the power supply cable (3) from the electrical mains and place it on the holder (4).
3. Lower the squeegee (21) with the lever (7).
4. Loosen the handwheels (22) and remove the squeegee (21).
5. Disconnect the vacuum hose (11) from the squeegee.
6. Clean the steel squeegee (Fig. 2) or the aluminium squeegee (Fig. 3). Clean the compartments (A, Fig. 2 or 3) and the
hole (B) especially. Check the front blade (C) and the rear blade (D) for integrity, cuts and tears; otherwise replace them
(see the procedure in the following paragraph).
7. Install the squeegee in the reverse order of removal.
16
All manuals and user guides at all-guides.com
909 6754 000(2)2006-10 A