Control Panel; Machine Structure - Description - Nilfisk CA 551 Manuel D'utilisation

CONTROL PANEL

51. Brush/pad-holder switch
52. Vacuum system switch
53. Hour counter (optional)
54. Solution flow control switches
54a. Flow increase switch
54b. Flow decrease switch
54c. Solution flow indicator
54b

MACHINE STRUCTURE - DESCRIPTION

Control panel (1) - It is the area where machine controls are located, see Control and Switch Description paragraph.
Handlebar (2) - Grasp it and use it to manoeuvre the machine.
Power supply cable (3) - Connect it to the electrical mains for machine operation.
Power supply cable holder (4) - Use it to roll up the power supply cable when it is not in use. Fasten the cable safely.
Solution rear filler neck (5) - Open it to pour solution in the tank. Use only low-foam detergents.
Water removable filler hose (optional) (6) - For easily filling the tank with water.
Squeegee lifting/lowering lever (7) - To lift or lower the squeegee.
Deck lifting/lowering pedal (8) - It has the following functions:
(8a) Pedal position when deck is lifted
(8b) Pedal position when deck is lowered
Rear steering wheel (9) - It allows the machine to steer.
Front wheels on fixed axle (10) - They bear the machine weight.
Squeegee vacuum hose (11) - It conveys the recovery water from the squeegee to the recovery water tank. To easily clean it,
remove the plug (32).
Recovery water drain hose (12) - It drains the recovery water from the tank.
Solution drain and level check hose (13) - It is equipped with level marks to check the solution level in the tank. Disconnect
the upper end to drain the tank.
Brush/pad-holder deck (14) - On the deck, brush or pad-holder and the relevant motors are installed.
Brush/pad-holder (15) - The machine can be equipped with one brush or one pad-holder with pad.
Solution tank (16) - It contains the solution.
909 6754 000(2)2006-10 A
All manuals and user guides at all-guides.com
54
54a
54c
USER MANUAL
53
52
51
S311302
7