Using The Standby Receptions - JVC KD-DB101 Manuel D'instructions

To store your favorite programme
types
You can store six favorite programme types.
Preset programme types in the number buttons
(1 to 6):
1
Select a PTY code (see steps ~ and Ÿ on
page 7).
2
Select the preset number (1 – 6) you want to
store into.
Ex.: When "ROCK M" is selected
3
Repeat steps 1 and 2 to store other PTY
codes into other preset numbers.
4
Finish the procedure.

Using the standby receptions

You can use two types of Standby Reception for FM
Station—TA Standby Reception and PTY Standby
Reception. TA Standby Reception is also available for
DAB services.
TA Standby Reception
TA Standby Reception allows the unit to switch
temporarily to Traffic Announcement (TA) from any
source other than AM.
The volume changes to the preset TA volume level if the
current level is lower than the preset level (see page 15).
8
To activate TA Standby Reception
The TP (Traffic Programme) indicator
either lights up or flashes.
• If the TP indicator lights up, TA Standby Reception is
activated.
• If the TP indicator flashes, TA Standby Reception is
not yet activated. (This occurs when you are listening
to a station or a DAB service without the signals
required for TA Standby Reception.)
To activate TA Standby Reception, tune in to another
station or a DAB service providing these signals. The
TP indicator will stop flashing and remain lit.
To deactivate the TA Standby Reception
The TP indicator goes off.
PTY Standby Reception
PTY Standby Reception allows the unit to switch
temporarily to your favorite PTY programme from any
source other than AM.
To activate and select your favorite PTY code for
PTY Standby Reception, see page 15.
The PTY indicator either lights up or flashes.
• If the PTY indicator lights up, PTY Standby Reception
is activated.
• If the PTY indicator flashes, PTY Standby Reception is
not yet activated.
To activate PTY Standby Reception, tune in to another
station. The PTY indicator will stop flashing and
remain lit.
To deactivate the PTY Standby Reception, select
"OFF" for the PTY code (see page 15). The PTY indicator
goes off.