Trouble Shooting; Fault Correction - Parkside PAS 900 A1 Traduction Des Instructions D'origine

GB IE

Trouble shooting

Problem
Device does not start
Low or lack of suction
12
All manuals and user guides at all-guides.com
Possible cause
Mains voltage is not present
The equipment is not
switched on
Safety stop due to missing
or incorrectly inserted pleat-
ed filter ( 13) or metal
filter cage ( 14)
Defective on/off switch
( 6)
Defective motor
The single-use thermal fuse
has disconnected the power
circuit
Suction hose (
tion tube ( 12) blocked
The metal container (
is not closed
The metal container (
is full
The pleated filter (
clogged
The air filter (
clogged
Pre-filter ( 15) is clogged
Pre-filter ( 15) reduces
the suction power

Fault correction

Check plug socket, power cord,
line, plug and fuse, where ap-
propriate, repair through electri-
cal specialist
Switch on the equipment (see
"Switching on/off")
Insert the pleated filter correctly
(see "Cleaning/Maintenance")
Repair through customer service
Remove obstructions and block-
11) or suc-
ages
10)
Close the metal container
10) Empty the metal container (see
"Cleaning/Maintenance")
Clean or replace the pleated
13) is
filter (see "cleaning/mainte-
nance")
18) is Clean the air filter (see "Clean-
ing/Maintenance")
Clean or replace pre-filter (see
"Cleaning/Maintenance")
To vacuum coarse dirt, remove
the pre-filter