VR
XP
PR 7
RAM
Available Time 00:28
Recording immediately
Before you start
1. Check the antenna cable is connected.
2. Press the OPEN/CLOSE button and place a recordeble disc on the
disc tray.
3. Check the remaining time on the disc.
DVD-RAM/DVD±RW/+R discs should be formatted or initialised in advance
before beginning recording. Most new discs are sold unformatted. Make
sure to format your unformatted discs before recording.
4. Press the OPEN/CLOSE button to close the disc tray.
Wait until LOAD disappears from the front panel display.
▌
Recording the current programme you are watching
1. Press the PROG/TRK (
station you want to record.
2. Press the REC SPEED button repeatedly, to select the recording
speed (quality).
→ SP → LP → EP → XP
3. Press the REC button.
▌
Recording from external equipment you are watching
1. Power on your DVD Recorder & VCR and switch to AV mode by
pressing the INPUT SEL. button on the remote control. The front panel
display changes in the following sequence.
→ PR → AV1 → AV2 → AV3 → DV
2. Press the REC SPEED button repeatedly to select the recording speed
(quality).
→ SP → LP → EP → XP
3. When your DVD Recorder & VCR is in the Stop mode, set the
operation mode of your external devices to play mode.
4. Press the REC button on your DVD Recorder & VCR when the image
from which you want to start recording is displayed.
To pause recording
Press the PLAY/PAUSE (
● Press the PLAY/PAUSE (
● You can switch channels by pressing the PROG/TRK (
while recording pauses.
To stop recording
Press the STOP button to stop a recording in progress.
● When using DVD-RAM/DVD±RW/DVD±R discs, the message
"Updating the disc information. Please wait for a moment." is
displayed.
English - 54
/
) buttons or number buttons to select the
) button to pause a recording in progress.
) button again to resume recording.
DVD-VR355 only
/
) buttons