Connecting & Setting Up - Samsung DVD-VR350 Manuel D'instructions

Connecting & Setting Up
Connecting DVD Recorder & VCR
to the TV using the RF Cable
■ Make sure that both the television and the
DVD Recorder & VCR are switched off before
connecting the cables.
1. Remove the aerial or network input cable from the
television.
2. Connect this cable to the 75Ω aerial jack marked
on the rear of your DVD Recorder & VCR.
3. Plug the RF Cable supplied into the
DVD Recorder & VCR.
4. Plug the other end of the RF Cable into the connector
previously used for the aerial on the television.
■ The RF cable connection of this product sends
only signals of TV.
You must connect SCART cable or Audio/Video
cables to watch a DVD and video tape from your
DVD Recorder & VCR.
TV
ANT
To ANT INPUT
Connecting the SCART Cable
▌ Case 1 : Connecting DVD Recorder &
VCR to the TV using the SCART Cable
You can connect your DVD Recorder & VCR to the
television using the SCART cable if the appropriate
input is available on the television. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your DVD Recorder
& VCR
jack on your
■
■
1. Connect the Aerial Cable.
2. Connect one end of the SCART cable to the AV1 (TV)
jack on the rear of the DVD Recorder & VCR.
3. Plug the other end into the appropriate connector on
the television.
To RF IN
To RF OUT
RF Cable
English - 16
Regardless of the type of connection chosen, you
must always connect the RF Cable. Otherwise,
no picture will be visible on the screen when the
DVD Recorder & VCR is switched off.
Make sure that both the television and the
DVD Recorder & VCR are switched off before
connecting the cables.
SCART Cable
TV
ANT
RF Cable
Aerial