System Setup; On-Screen Menu Navigation; Plug & Auto Setup - Samsung DVD-VR350 Manuel D'instructions

System Setup

DVD-Recorder
Setup
No Disc
Programme
System
Setup Clock Set
Language
Audio
Video
Parental Control
Install
MOVE OK RETURN EXIT
DVD-Recorder Auto Setup
No Disc
Language Set English
Français
Deutsch
Español
Italiano
Nederlands
Русский
MOVE OK RETURN
DVD-Recorder Setup
No Disc
Country Selection
Autom. Setup
A NL S PL
Man. Sendereinst.
√
B I CH CZ
TV-System : K
DK N TR Others
HF-Ausgang : CH 36
FIN P GR
D E HU
MOVE OK RETURN
Auto Channel Memory
50%
Stop

On-Screen Menu Navigation

The on-screen menus allow you to enable or disable various
functions on your DVD Recorder & VCR.
Press the MENU button to open the on-screen menu and then use
►
the following buttons to navigate through the on screen menus.
►
►
►
1. ▲▼, ◄► Buttons
►
►
Press these buttons on the remote control to move the selection bar ▲
►
▼, ◄► to cycle through the menu options.
2. OK Button
Press this button on the remote control to confi rm any new settings.
3. RETURN Button
Press this button on the remote control to return to the previous menu
screen displayed or to exit the on-screen menu.
4. EXIT Button
Press this button to exit the on-screen menu.
Plug & Auto Setup
The DVD Recorder & VCR will automatically set itself up when it is
plugged into the mains for the fi rst time.
TV stations will be stored in memory. The process takes a few
minutes. The DVD Recorder & VCR will then be ready for use.
1. Connect the RF cable as indicated on page 16.
• Connecting Your DVD Recorder & VCR to the TV using the RF Cable
and Scart cable (or Audio/Video cable).
2. Plug the DVD Recorder & VCR into the mains.
• "Auto" in the front panel display fl ickers.
3. Press the ▲▼ buttons select desired language, then press the OK button.
The message "Auto Setup will be started. Check antenna and TV
cable connection." is displayed.
4. Start the auto setup.
5. Select Country using the ▲▼◄ ► buttons, then press OK button.
√
• Refer to following abbreviation table when selecting "Country".
√
A(Austria)
√
B(Belgium)
DK(Denmark)
FIN(Finland)
D(Deutschland) E(Spain)
6. Start the auto scanning.
7. Wait current time and date are displayed automatically.
8. Check the date and time.
• if it is: Correct
Press OK button then the data and time will be saved.
• if it is: Incorrect
Refer to "Setting the Date and Time" (See page 23) menu, when you
want to change the date and time.
English - 22
NL(Netherlands) S(Sweden)
I(Italy) CH(Swiss)
N(Norway) TR(Turkey)
P(Portugal) GR(Greece)
HU(Hungray)
PL(Poland)
CZ(Czech)
Others