Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
GENERAL SAFETY INSTRUCTIONS
GENERAL SAFETY WARNINGS
WARNING! For your own safety, read this manual
and the general safety instructions carefully
before using the appliance. Your tool should
only be given to other users together with these
instructions.
Working area
• Keep working area clean and well lit. Cluttered
and dark areas can lead to accidents.
• Do not operate the tools in potentially
explosive surroundings, for example, in the
presence of flammable liquids, gases or dust.
The tools create sparks which may ignite the
dust or fumes.
• Keep children and bystanders at a distance
when operating the tool. Distractions can cause
you to lose control of it.
Electrical safety
Always check that the power supply
corresponds to the voltage on the
rating plate of the charger.
• Always check that the power supply
corresponds to the voltage on the rating plate.
• The tool plugs must match the outlet. Never
modify the plug in any way. Do not use adapter
plugs with grounded tools. Unmodified plugs
and matching outlets will reduce the risk of a
lethal electric shock.
• Avoid body contact with grounded surfaces
such as pipes, radiators, kitchen ranges and
refrigerators. There is an increased risk of a lethal
electric shock if your body is grounded.
• Do not expose the tools to rain or wet
conditions. If water gets inside the tool, it will
increase the risk of a lethal electric shock.
• Do not damage the cord. Never use the cord
for carrying, pulling or unplugging the tool.
Keep the cord away from heat, oil, sharp edges
or moving parts. Damaged or entangled cords
increase the risk of a lethal electric shock.
• When operating the tool outdoors, use an
extension cable suitable for outdoor use. Using a
cord suitable for outdoor use reduces the risk of
a lethal electric shock.
• If operating the tool in a damp location is
unavoidable, use a power supply protected by
a residual current device (RCD) . Using an RCD
reduces the risk of a lethal electric shock.
Personal safety
• Stay alert, watch what you are doing and use
common sense when operating the tool. Do
not use the tool when you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention when operating the tool
may result in serious personal injury.
• Use safety equipment. Always wear eye
protection. Using safety equipment such as a
dust mask, non-skid safety shoes, a hard hat, or
hearing protection whenever it is needed will
reduce the risk of personal injury.
• Avoid accidental starts. Ensure the switch is
in the off position before inserting the plug .
Carrying the tools with your finger on the switch
or plugging in the tools when the switch is in
the on position makes accidents more likely.
• Remove any adjusting keys or spanners before
turning on the tool . A spanner or key left
attached to a rotating part of the tool may result
in personal injury.
• Do not reach out too far. Keep your feet firmly
on the ground at all times. This will enable
you retain control over the tool in unexpected
situations.
• Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from the tool. Loose clothes, jewellery or
long hair can become entangled in the moving
parts.
Use and care
• Do not expect the tool to do more than it can.
Use the correct tool for what you want to do.
The tool will achieve better results and be safer if
EN
25
Publicité
Chapitres
Dépannage
