Important Safety Instructions - Haussmann AGT103-H Guide De L'utilisateur

All manuals and user guides at all-guides.com

IMPORTANT SAFETY INSTRUCTIONS

10. STORE IDLE EQUIPMENT. Store equipment in a dry area to inhibit rust. Equip
ment also should be in a high location or locked up to keep out of reach of
children.
11. DON'T FORCE THE TOOL. It will do the job better and more safely at the rate
for which it was intended.
12. USE THE RIGHT TOOL. Don't force a small tool or attachment to do the work
of a larger industrial tool. Don't use a tool for a purpose for which it was not
intended.
13. DRESS PROPERLY. Don't wear loose clothing or jewelry; they can be caught
in moving parts. Protective, non-electrically conductive gloves and non-skid
footwear are recommended when working. Wear protective hair covering to
contain long hair and keep it from harm.
14. USE EYE PROTECTION. Use a full-face mask if the work you're doing produces
metal filings, dust or wood chips. Goggles are acceptable in other situations.
Wear a clean dust mask if the work involves creating a lot of fine or coarse
dust.
15. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across machines that are running.
16. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and changing accessories.
Keep handles dry, clean and free from oil and grease.
17. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
before plugging in.
18. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can fly
off a rotating part and result in personal injury.
19. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
your tool repaired before using it.
20. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY AD-
JUSTMENTS. Changing attachments or accessories can be dangerous if the
tool could accidentally start.
21. STAY ALERT. Watch what you are doing & use common sense. Don't operate
any tool when you are tired, or under the influence of alcohol, drugs or
medications that cause drowsiness.
22. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is dam-
aged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any ones that are loose. Any
part that is damaged should be properly repaired or replaced by an authorized
service centre unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service centre. . Don't use
the tool if switch does not turn it on and off properly.
23. REPLACEMENT PARTS. When servicing, use only identical replacement parts.
24. SERVICE AND REPAIRS should be made by qualified repair technicians at an
authorized repair centre. Improperly repaired tools could cause serious shock
or injury.
,
15