Haussmann AGT18-1.3 Manuel De L'utilisateur page 29

All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
(19) and pull outwards until it snaps into place.
(fig C)
ADJUSTMENTS
Using Adjustable Handle (fig D)
The adjustable handle (4) can be set in various
positions:
• To change the position undo the handle knob
(3) and move the adjustable handle (4)
• Tighten the handle knob (3) securely to fix the
adjustable handle (4) in the desired position.
Adjusting shaft length(fig. E)
• Loosen the locking collar (5)
• Pull the shaft out to increase, or push the shaft
in to decrease the height/length.
• Retighten the locking collar (5).
Adjusting cutting head angle (fig. F/G)
• To change the angle depress the foot pedal (16)
and move the shaft (6) to the desired position
• Release the foot pedal (16). (fig G)
Converting from trimmer to edger (fig. H)
Your trimmer can easily be converted from
trimmer to Edger by the touch of one button:
• Depress the angle adjusting knob (17)
• Turn the shaft 180º to position the trimmer
head for trimming/edging as shown.
• Release the angle adjusting knob.
OPERATION
Cutting and Edging
Remove stones, loose pieces of wood and other
objects from the cutting area.
The blade continues to rotate for
a few seconds after the trimmer is
switched off.
• Allow the motor/blade to stop rotating before
switching on again.
• Do not rapidly switch off and on.
Switching On and Off
• Press safety switch (18) to the left or right.
• Press switch (1) and hold depressed.
• Release switch (1) for switching off.
Cutting Grass (Fig I)
Move the trimmer left and right, keeping it
well away from your body. The trimmer can
efficiently cut grass up to a height of 6" (15 cm).
Cut taller grass in stages.
Trimming Edges (Fig. J)
Guide the trimmer along the edge of the
lawn. Do not allow the cutting blade to
contact paved surfaces, stones or garden
walls, since this will wear the blade rapidly.
The lawn trimmer is in its trimming edge
function when the handle is rotated over
180°.
Plant protector (Fig K, L)
Always use the plant protector bar. (It also
protects the cutting blade from unwanted heavy
impacts.)
Cutting around trees and bushes (Fig L)
• Carefully cut around trees and bushes so that
they do not come into contact with the cutting
blade.
• Plants can die if you damage the bark.
EN
29