Troubleshooting - Haussmann AGT18-1.3 Manuel De L'utilisateur

All manuals and user guides at all-guides.com

TROUBLESHOOTING

The following table gives checks and actions that you can perform if your machine does not operate
correctly. If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove battery before investigating fault.
Symptom
Can not fit guard over
cutting disc
Machine fails to operate
Machine functions
intermittently
Excessive vibration/ noise -Machine fault
Cutting time low on one
battery charge
Blade will not move
Machine is not cutting
No charging procedure
possible due to defective
battery
The LED indicators
do not light up after
plugging the mains plug
into the socket and
inserting the battery into
the charging
Possible Cause
Incorrect assembly
Battery discharged
-Internal wiring
defective
-On/Off switch defective
-Blade broken
-Battery not used for
long period or initial usage
-Grass too high
-Battery worn out
-Battery discharged
-Machine fault
-Blade broken
-Battery not fully charged
-Grass entangled
around cutting disc
-The battery
temperature is not
within the allowable
temperature range
-The contacts of the
battery are contaminated
-The battery is defective,
due to a disconnection in
the battery (individual cells)
-The charger plug is
not inserted
(properly).
-Socket, cable or
charger are defective
Remedy
Remove cutting disc and fit guard, see
also Assembly
Recharge battery, see also Charging
Procedure
-Contact Service Agent
-Contact Service Agent
-Contact Service Agent
-Replace blade
-Fully charge battery, see also Charging
Procedure
-Cut in stages
-Replace the battery
-Recharge battery, see also Charging
Procedure
-Contact Service Agent
-Replace blade
-Recharge battery, see alsoCharging
Procedure
-Remove grass
-Get the battery temperature within the
allowable temperature range (0C°
to 45°C) either by cooling down or
warming up. As soon as the battery
temperature is within correct range
again, the battery charger automatically
switches to rapid charging
-Clean the contacts (e. g. by inserting
and removing the battery several times)
or replace the battery, as required
-Replace the battery
-Insert the plug (fully) into the socket
-Check the mains voltage and if
necessary, have the battery charger
checked by an authorized customer
service centre.
EN
31