Stihl HLA 65 Notice D'emploi page 52

English
Switching On
The starter battery of a factory-new
machine is not fully charged.
Recommendation: Fully charge the
battery before using it for the first time.
If necessary, remove the cover from
N
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the Battery
1
Insert the battery (1) in the power
N
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
50
All manuals and user guides at all-guides.com
Switching on the Machine
Your machine cannot be switch on while
it is in the transport position.
Make sure you have a secure and
N
firm footing.
Stand upright – hold the power tool
N
in a relaxed position.
Make sure the cutting blades are not
N
touching the ground or any other
objects.
Hold your trimmer with both hands –
N
one hand on the control handle – the
other hand on the loop handle or
handle hose.
Unlock the power tool by moving the
N
retaining latch (2) to ‚.
Push down the trigger switch
N
lockout (3) and depress the trigger
switch (4) and hold them in that
position.
The motor runs only if the retaining
latch (2) is on ‚ and the trigger switch
lockout (3) and trigger switch (4) are
operated simultaneously.
Trigger
2
Motor speed can be controlled with the
trigger switch. Depress the trigger switch
to accelerate the motor.
2
3
4
HLA 65