General Safety Instructions; Intended Use - Scheppach Ox 3-1200 Traduction Des Instructions D'origine

Dispose of waste oil correctly (waste oil col-
lection point on site). Do not dump waste oil in
the ground or mix it with waste.
Do not remove or modify protection and safety
devices.
Only the operator is allowed in the work area
of the machine. Keep other people and ani-
mals (minimum distance 5 m) at a distance.
Do not remove jammed trunks with your
hands.
Caution! Switch off the engine before repair,
maintenance and cleaning. Unplug the mains
plug.
Danger of bruising and injury from sharp
edges; never touch danger areas when the
cleaver is moving.
High-voltage, danger to life!
The machine must only be operated by one
person!
2x
Oil
Loosen the vent bolt two revolutions, before
Oil
starting work. Close before transport.
2x
1. 2.
Caution! Moving machine parts!
Do not transport the device in the horizontal
position!
Familiarise yourself with the two-hand control before
operating the machine! Read the operating instruc-
tions thoroughly.
Additional warnings without symbols:
• Do not remove the casing.
In this operating manual, points concerning your
safety will be marked with this symbol: m
m General Safety Instructions
WARNING: If you use electric tools, you should
observe the general safety measures mentioned
below in order to reduce the risk of fire, electric
shock, and personal injury.
Please read all instructions before working with
these tools.
• Observe all safety instructions and warnings for
the machine.
• Keep all safety instructions and warning labels on
the machine complete and in legible condition.
• You must not remove the safety devices on the ma-
chine or make them inoperative.
• Inspect the power cords. Do not use faulty power
cords.
• Check that the two-hand control is functioning cor-
rectly before operation.
All manuals and user guides at all-guides.com
• The operator must be at least 18 years of age.
• Wear work gloves during work.
• Attention during work: injury hazard to fingers and
• When splitting heavy or bulky materials, use ap-
• Installation, repairs and maintenance work on the
• All guards and safety mechanisms must be rein-
• Switch the motor off when leaving the working area.
• The log splitter may only be operated by a single
• Wear protective gear (protective goggles/mask,
• Never split logs with nails, wire or other objects in
• Logs already split and shavings pose a threat within
• Never put your hands on moving parts while the
• Only split logs with a maximal length of 1,300 mm.
• Before starting work, check the hydraulic lines and
• Check protective units and functions of the ma-
• Do not put your hands into the splitting area.
• Should the wood jam, turn the machine off and re-
Warning! This electric tool generates an electromag-
netic field during operation. This field can impair ac-
tive or passive medical implants under certain condi-
tions. In order to prevent the risk of serious or deadly
injuries, we recommend that persons with medical
implants consult with their physician and the manu-
facturer of the medical implant prior to operating the
electric tool.
This machine complies with the current EC ma-
chinery directive.
• The hydraulic log splitter is designed for "stationary
• Never split logs lying horizontally or across the
• The manufacture's safety, working, and mainte-
Trainees must be at least 16 years old, but may
only work with the machine under supervision.
hands.
propriate appliance for support. Switch motor off for
retooling, adjustment, and cleaning, as well as for
maintenance and troubleshooting. Pull power plug!
electrical installation may only be carried out by
qualified personnel.
stalled immediately after completing the repairs or
the maintenance work.
Pull power plug!
ADDITIONAL SAFETY INSTRUCTIONS FOR LOG
SPLITTERS
person.
gloves, hearing protection, and safety shoes) to
protect against possible injuries.
them.
the working area. There is the risk of tripping, slip-
ping, or falling. Always keep the working area tidy.
machine is switched on.
hoses.
chine.
move the wood carefully.
m Intended Use
operation", logs may only be split standing upright
and along the grain. The dimensions of the logs
to be split:
wood length: 60/96,5/104/133 cm
ø min/max: 10/40 cm
grain.
nance instructions as well the dimensions stated
in the technical specifications must be observed.
english 13