Cleaning The Unit - Pioneer HTP-710 Mode D'emploi

10 Additional information
S-SWR500FS Speaker system (HTP-
FS510)
• Front speakers
Enclosure. . . . . . . . Closed-box floorstanding type
System . . . . . . . . . . . . . . . . . . . . . . . . 2-way system
Speakers:
Woofer . . . . . . . . . . . . . . . 5.2 cm cone type x2
Tweeter . . . . . . . . . . . . 2.6 cm semi-dome type
Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ω
Frequency range . . . . . . . . . . . . . 60 Hz to 20 kHz
Dimensions:
Without speaker stand
. . . . . . . 77 mm (W) x 395 mm (H) x 55 mm (D)
With speaker stand
. . . . . 126 mm (W) x 462 mm (H) x 126 mm (D)
Weight:
Without speaker stand . . . . . . . . . . . . . . . 1.0 kg
With speaker stand. . . . . . . . . . . . . . . . . . 1.3 kg
• Accessories
Speaker cables . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Speaker stand bases . . . . . . . . . . . . . . . . . . . . . . 2
Poles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Gaskets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Screws (short) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Screws (long) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
S-SB510 Speaker system (HTP-SB510)
• Speaker
Enclosure. . . . . . . . . . . . . . . . . . . . . . . . Closed-box
System . . . . . . . . . . . . . 4 cm x 7 cm 1-way system
Speakers . . . . . . . . . . . .4 cm x 7 cm cone type x6
Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ω
Frequency range . . . . . . . . . . . . . 70 Hz to 20 kHz
Dimensions:
Without speaker stand
. . . . . . . 800 mm (W) x 57 mm (H) x 85 mm (D)
With speaker stand
. . . . . . . . 800 mm (W) x 100 mm or 88 mm (H)
Weight:
Without speaker stand . . . . . . . . . . . . . . . 1.8 kg
With speaker stand. . . . . . . . . . . . . . . . . . 1.9 kg
90
En
All manuals and user guides at all-guides.com
(magnetically shielded)
x 102 mm (D)
• Accessories
Speaker cable. . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Speaker stands . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Screws . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Small Non-skid pads
(for speaker stand or speaker) . . . . . . . . . . . . . .10
Note
• The specifications are applicable when the
power supply is 230 V.
• Specifications and the design are subject
to possible modifications without notice,
due to improvements.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser
diluted five or six times with water, and
wrung out well, and then wipe again with a
dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.
Published by Pioneer Corporation.
Copyright © 2010 Pioneer Corporation.
All rights reserved.