Getting Started; Automatically Setting Up For Surround Sound (Mcacc) - Pioneer HTP-710 Mode D'emploi

Getting started

Chapter 4
Getting started
Automatically setting up for
surround sound (MCACC)
The Auto Multi-Channel Acoustic Calibration
(MCACC) setup measures the acoustic
characteristics of your listening area, taking
into account ambient noise, speaker size and
distance, and tests for both channel delay and
channel level. After you have set up the
microphone provided with your system, the
system uses the information from a series of
test tones to optimize the speaker settings and
equalization for your particular room.
CAUTION
• The test tones used in the Auto MCACC
Setup are output at high volume.
Important
• When using HTP-FS510 and HTP-SB510
models, always use the Auto MCACC setup
function. If this setup is not performed,
various problems may occur, including an
inability to hear screen dialogue, or to hear
sound from the surround channel.
In the event the Auto MCACC setup is not
used, perform the manual Speaker
Setting instead.
• The OSD will not appear if you have
connected using the HDMI output to your
TV. Use composite connections for system
setup.
• The Auto MCACC Setup will overwrite any
existing speaker settings you've made.
All manuals and user guides at all-guides.com
• Before using the Auto MCACC Setup, the
iPod USB function should not be selected
as an input source.
SYSTEM
INPUT SELECT SOURCE
SYSTEM
TV CONTROL
INPUT
CH
1 Connect the microphone to the MCACC
SETUP MIC jack on the rear panel.
Make sure there are no obstacles between the
speakers and the microphone.
If you have a tripod, use it to place the
microphone so that it's about ear level at your
normal listening position. Otherwise, place the
microphone at ear level using a table or a chair.
Microphone
Tripod
2 Switch on the system and your TV.
Switch the TV input so that it connects to the
system in analog.
MASTER
AUDIO TUNER EDIT
VOLUME
PARAMETER TOOLS
MENU
TOP
MENU
ENTER
HOME
MENU
SETUP
iPod CTRL RETURN
ST/MONO
PTY SEARCH
04
51
En