Basic Operation; Choosing The Input Signal - Pioneer HTP-710 Mode D'emploi

04 Getting started

Basic operation

Procedures for listening to audio from a radio
or connected other component.
SYSTEM
INPUT SELECT SOURCE
SYSTEM
TV CONTROL
INPUT
VOL
DIMMER SIGNAL SEL
BD MENU
1 Turn on the power of the playback
component.
2 Press  SYSTEM to turn on the power of
this system.
3 Select the source you want to playback.
Use the MULTI CONTROL (or INPUT
SELECTOR) buttons.
• Select the type of audio input signal if
required (see below).
4 Start playback of the component you
selected in step 1.
5 Select the listening mode.
Use the listening mode buttons.
6 Press MASTER VOLUME +/– to adjust the
volume.
Note
1 • This system can only play back Dolby Digital, PCM (32 kHz to 96 kHz) and DTS (including DTS 96 kHz / 24 bit) digital
signal formats. The compatible signals via the HDMI terminals are: Dolby Digital, DTS, SACD (DSD 2 ch), PCM (32
kHz to 192 kHz sampling frequencies), Dolby TrueHD, Dolby Digital Plus, DTS-EXPRESS, DTS-HD Master Audio and
DVD Audio (including 192 kHz). With other digital signal formats, set to A (analog).
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise,
make the proper digital connections (page 33) and set the signal input to C1/O1/O2 (DIGITAL).
• Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your
DVD player.
2 When the HDMI option in Setting the Audio options on page 69 is set to THRU, the sound will be heard through your
TV, not from this system.
54
En
All manuals and user guides at all-guides.com
TUNER EDIT
AUDIO
PARAMETER
TOOLS
TOP
MENU
ENTER
CH
HOME
MENU
SETUP
RETURN
iPod CTRL
ST/MONO
PTY SEARCH
DTV/TV
BASS TRE

Choosing the input signal

On this system, it is possible to switch the
input signals for the different inputs as
described below.
MASTER
VOLUME
MENU
1 Press
MUTE
2 Press SIGNAL SEL to select the input
signal corresponding to the source
component.
When DIGITAL (C1/O1/O2) or HDMI (H) is
selected and the selected audio input is not
provided, A (analog) is automatically selected.
Each press cycles through the following:
• A – Selects the analog inputs.
• DIGITAL – Selects the digital input. The
coaxial 1 input is selected for C1, and the
optical 1 or 2 audio input is selected for
O1 or O2.
• HDMI – Selects an HDMI signal. H can be
selected for BD/DVD, VIDEO or DVR/VCR
input. For other inputs, HDMI cannot be
selected.
When set to DIGITAL or HDMI, 2 lights when
a Dolby Digital signal is input, and DTS lights
when a DTS signal is input.
When the HDMI is selected, the A and
DIGITAL indicators are off (see page 44).
1
SYSTEM
TV CONTROL
INPUT
CH
VOL
DIMMER SIGNAL SEL
BD MENU
on the remote control.
2