Pioneer HTP-710 Mode D'emploi page 49

Controls and displays
Press first to access:
BASS –/+
Use to adjust the channel level of the
1
subwoofer.
TRE –/+
Use to adjust Treble
Press TV first to access:
DTV/TV
Switches between the DTV and analog TV
input modes for Pioneer TVs.
14 MUTE
Mutes/unmutes the sound.
15 Number buttons and other component
controls
Use the number buttons to directly select a
radio frequency (page 60) or the tracks on a
CD, DVD, etc. There are other buttons that can
be accessed after the
pressed. (For example MIDNIGHT, etc.)
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.
S.RETRIEVER
Press to restore CD quality sound to
compressed audio sources (page 65).
EQ
Press to switch on/off Acoustic Calibration
EQ setting (page 66).
CH SELECT
Press repeatedly to select a channel, then
use +/– to adjust the level (page 74).
CH SELECT +/–
Use to adjust the channel level.
SB CH
Use to select the surround back channel
mode (page 68).
Note
1 The tone controls are disabled when the listening mode is set to DIRECT or PURE DIRECT.
All manuals and user guides at all-guides.com
1
button is
PHASE
Press to switch on/off Phase Control
(page 66).
MIDNIGHT
Press to switch on/off Midnight listening
(page 69).
SLEEP
Press to change the amount of time before
the system switches into standby (30 min
– 60 min – 90 min – Off). You can check
the remaining sleep time at any time by
pressing SLEEP once.
16 DISPLAY
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
17 SHIFT
Press to access the 'boxed' commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (* ) in this section.
03
49
En