IKRA BAS 3020 Manuel D'utilisation page 54

7. REFERENCE
Ratings: Pole Chain Saw BAS 3020
Motor
Engine output
Engine type
Cubic capacity
Fuel
Tank volume
Maximum engine speed
Idling speed
Max. speed of the cutting tool
Fuel consumption
Weight
Pole chain saw
Chain speed
Cutting length
Chain type
Toothing
Oil tank volume
Noise level
Vibration - full throttle
Vibration - idling speed
Brush Cutter / Grass Trimmer
Cutting diameter
(blade)
Cutting diameter
(nylon line)
Cord diameter
Overall cord length
Cord extension
Noise level
Vibration - full throttle
Vibration - idling speed
measured acoustic capacity level
guaranteed acoustic capacity level
Technical changes reserved.
The Pole chain saw are manufactured in accordance with the provisions of EN ISO 11680-1 and fully comply with the
provisions of the German Equipment and Product Safety Act.
The brush cutter are manufactured in accordance with the provisions of EN ISO 11806-1:2011 and fully comply with
the provisions of the German Equipment and Product Safety Act.
Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons
with other petrol equipment as well as temporary estimates of the load through the vibrations.
WARNING! The vibration value may vary according to the usage of the machine and its fitted equipment, and be
higher than the one indicated. Safety measures must be established to protect the user and must be based on the load
estimate generated by the vibrations in real usage conditions. In this regard, all the operational cycle phases must be
taken into consideration, such as switching off or idle running.
Warning: Prolonged exposure to vibrations can cause injuries and neurovascular disorders (also called "Renaud's
syndrome"or "white hand"), especially to people suffering from circulation disorders. The symptoms can regard the
hands, wrists and fingers and are shown through loss of sensitivity, torpor, itching, pain and discolouring of or structural
changes to the skin. These effects can be worsened by low ambient temperatures and/or by gripping the handgrips ex-
cessively tightly. If the symptoms occur, the length of time the machine is used must be reduced and a doctor consulted.
When working with the device, a certain level of noise cannot be avoided. Noisy work should be scheduled for hours,
during which it is allowed by statute or other local regulations. Adhere to any applicable rest times and limit your work-
ing time to the necessary minimum time. For your personal protection and the protection of people nearby, suitable
hearing protection must be worn.
All manuals and user guides at all-guides.com
kW
cm³
lubricated petrol
ml
min
-1
min
-1
min
-1
kg/h
kg
m/sec
" / mm
ml
dB (A)
2
m/s
2
m/s
cm
cm
mm
m
dB (A)
2
m/s
2
m/s
dB (A)
dB (A)
according to 2000/14/EG
GB-25
1,0
2-stroke
30
40:1
600
10.500
3.000
8.500
0.38
4,9
21
8 / 203
Oregon 91PJ033X
7T - 3/8"P
150
102
[K=3,0 dB(A)]
13,254
[K=1,5 m/s²]
6,954 2
[K=1,5m/s ]
23
43
2,2
2 x 2,5
Tap'n go
94,5
[K=3,0 dB(A)]
9,9
[K=1,5 m/s²]
2
3,2 [K 1,5 m/s ]
109,7
[K 3,0 dB(A)]
112