IKRA BAS 3020 Manuel D'utilisation page 49

4 BRUSH CUTTER AND TRIMMER
Main parts and Control
6
2
1
7
1 = Cord cutting head
2 = Cutting cord
3 = Cutting blade
4 = Protective shield for metal blade
5 = Protective shield for cutting cord
6 = Shaft
7 = Gear housing
8 = Cut off blade
Definition
1. cord cutting head
use to cut grass
2. cutting cord
use to cut grass
3. cutting blade
use to cut frutex
4. protective shied for metal blade
protect the user away from danger
5. protective shied for cutting cord
protect the user away from danger
6. shaft
connect the gear housing and the coupling sleeve
7. gear housing
transfer the power to cuting unit
8. cut off blade
cut off the cord
Mounting the brusch cutter
All manuals and user guides at all-guides.com
8
5
4
3
Step 1:
put the metal protection cover on the gear box and align
it according to the mounting bores. inset the screws as
shown and tighten them firmly.
Warning!
Make sure that all components are mounted and assem-
bled correctly anf all screws are properly tighten.
Step 2:
Remove the spilt pin from the end of the drive shaft
Step 3:
Insert an Allen Key into the hole on the side of the lower
retaining flange to prevent the gear from turning. Use the
included wrench to unscrew the nut turning it clockwise.
Step 4:
Remove the upper retaining flange.
Mount the blade as shown. Put the flange with its flat sur-
face onto the cutting blade.
GB-20