IKRA BAS 3020 Manuel D'utilisation page 51

Fold a 5 m x 2,2 mm cord in half. Put the loop end into the
slot of the spool. The slot is located in the centre wall that
divides the two cord chambers from each other.
Roll both halves of the cord concurrently around the spool.
The wrapping direction is engraved in the spool: "Wind
Cord". Make sure that the cord is always tensioned and
that each half of the cord stays in the proper separate
spool housing. Roll up the cord until 15 cm of cord remain
at each end.
Lead each cord end through the openings at the respec-
tively opposite side of the coil.
Lead the spring over the spindle and thread the cord ends
through the eyelets in the housing.
Lead the coil into the housing while pulling the cord ends
through the eyelets. Make sure that the spring is positioned
correctly in relation to the coil and housing.
All manuals and user guides at all-guides.com
When the coil sits in its correct position in the housing, push
it firmly into the housing so that the spring is tensioned.
Firmly pull at both ends of the cord so that the cord cannot
be pinched between the coil and housing. Maintain the
spring tension through continuous pressure on the coil in
the housing and fix the screw by turning it anticlockwise.
Fasten the screw fingertight
Cut the cord to about 17 cm to avoid excessive load to the
engine during the starting and warm-up phase
5 706 MM EXTENSION SHAFT
To reach a high position, you can add an extension shaft
between the main body and add-on attachment.
Note: The brush cutter can't use the extension shaft.
When use chain saw to cut high branches,the falling twigs
and saw dust may hurt youe face and hands.Always wear
helmets with visor and protective gloves to prevent dam-
age to your view and skin. Tight fitting clothingand safety
boots should also be worn to prevent injury.
GB-22
only.
.
17 cm