IKRA BAS 3020 Manuel D'utilisation page 41

Masquer les pouces Voir aussi pour BAS 3020:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 56
Gasoline
1L
5L
Dispose of empty mixing-oil canisters only at authorized
disposal locations.
Fueling
Before fueling, clean the filler cap and the area around it
to ensure that no dirt falls into the tank.
Always thoroughly shake the mixture in the canister be-
fore fueling your machine.
In order to reduce the risk of burns or other per-
sonal injury from escaping gas vapor and fumes,
remove the fuel filler cap carefully so as to allow
any pressure build-up in the tank to release slowly.
After fueling, tighten fuel cap as securely as pos-
sible by hand.
Starting / Stopping the Engine
Starting
1 Put the stop switch in the position '1''1'
2 Slide the choke to position 'start'. This is not required
in case of a warm start.
All manuals and user guides at all-guides.com
Oil
3 Push the fuel pump 6 times.
25ml
125ml
4 Push the starter rope 2-3 times, to start the motorit is
5 Slide the chock to RUN positon, slightly push the throt-
6 Let the motor idle for about 10 seconds to warm up.
7 If the motor does not start please repeat the upward-
Stopping
1 Release the throttle trigger. Let the engine idle. push-
GB-12
required to evenly, quickly pull the rope.
tle trigger and pull the starter rope again until the mo-
tor starts running. To push the throttle trigger(1) it is
necessary to first push the locking lever(2).
2
1
steps.
the ignition switch to position "stop". The engine will
now stop.

Publicité

Table des Matières
loading

Table des Matières