Rewind Starter; Parts And Controls - IKRA BAS 3020 Manuel D'utilisation

Rewind Starter

To help prolong the wear life of the starter rope, ob-
serve the following points:
• Pull the starter rope only in the direction specified.
• Do not pull the rope over the edge of the guide bushing.
• Do not pull out the rope more than specified since it
might break.
• Do not let the starter grip snap back, guide it slowly
into the housing. See also chapter "Starting / Stopping
the Engine"!
Replace a damaged starter rope in good time or have
it replaced by your Sunray dealer!
3 POLE CHAIN SAW

Parts and Controls

10
1 = Saw Chain
2 = Guide Bar
3 = Oil Tank
4 = Oil Filler Cap
5 = Drive tube
6 = Chain Sprocket Cover
7 = Hook
8 = Chain Guard (Scabbard)
9 = Chain Sprocket
10 = Chain Tensioner
Definitions
1. Saw Chain
A loop consisting of cutters,tie straps and drive links.
2. Guide Bar
Supports and guides the saw chain.
3. Oil Tank
Tank for chain lubricating oil.
4. Oil Filler Cap
For closing the oil tank.
5. Drive tube
Device to connect the engine with the gearbox.
6. Chain Sprocket Cover
Covers the sprocket.
7. Hook
For hooking machine to branch and pulling branches
away.
8. Chain Guard (Scabbard)
Covers chain for transportation and during out-of-
service periods.
All manuals and user guides at all-guides.com
9. Chain Sprocket
10. Chain Tensioner
Using the Pole Pruner
Preparations:
• Wear suitable protective clothing and equipment – see
• Start the engine.
• Put on the shoulder strap.
Cutting sequence
To allow branches a free fall, always cut the lower branch-
es first. Prune heavy branches (large diameter) in several
controllable pieces.
Working position
Hold the control handle with your right hand, and the drive
tube with your left hand. Your left arm should be extended
to the most comfortable position.
The shaft should always be held at an angle of 60° or
less!
The most convenient working position is a tool angle of
60°, but any lesser angle may be used to suit the situa-
tion concerned.
Cross-cutting
GB-14
The toothed wheel that drives the saw chain.
Permits precise adjustment of chain tension.
„Safety Precautions".
Never throw cuttings into the household garbage
can – they can be composted!
Never stand directly under the branch you are cut-
ting – be wary of falling branches. Note that a branch
may spring back at you after it hits the ground!