Cold Start - AL-KO BC 330 MT Mode D'emploi

Cold start

IMPORTANT – Danger of kickback!
Always pull the starter cord straight out. Do not let
it spring back abruptly.
1. Set the START/STOP switch (19-4) to START.
2. Push in the throttle lever detent (19-5) and press the
throttle lever at the same time (19-6).
3. Set the choke lever (19-1) to the CHOKE position.
4.
until petrol/foam is visible in the suction pump.
5. Pull the starter cord (19-2) out slowly until
encountering resistance, then pull it further out quickly
to the end of its travel, and guide the starter toggle
back slowly so that the starter cord will be wound in
correctly.
6.
7. Set the choke lever to the RUN position as soon as
8. Pull out the starter cord until the engine starts.
9. Repeat steps 1-8 if the engine does not start.
10. The engine runs at idling speed when the throttle
lever is released.
Warm start
1. Set the ignition switch to START.
2. Set the choke lever to RUN.
3. Lock the throttle lever as described for "Cold start".
4. Pull the starter cord quickly a maximum of 6 times
– the engine starts. Keep the throttle lever fully
depressed until the engine runs smoothly.
If the engine does not start:
Set the choke lever to RUN
Pull the starter cord 5 times
If the engine still does not start:
Wait for 5 minutes and then try again with the
throttle lever depressed
Refer to the "Help in case of malfunctions" chapter.
32
Switching off the engine
1. Release the throttle lever and let the engine run at
idling speed.
2. Set the ignition switch to STOP.
IMPORTANT!
The engine runs on when shutting down – danger
of injury!
Operation
Whilst trimming and cutting, always keep the engine
running in its upper engine speed range
Safety notes
IMPORTANT!
It is essential to comply with the safety and
warning instructions in this documentation and on
the machine!
Wear appropriate working clothes
Make sure you can stand securely when working
Always operate the machine with two hands
Keep your body and clothing away from the cutting tool
Keep third parties out of the danger area
Never raise the spool attachment over knee height
when the machine is operating
When mowing on a slope, always stand below the
cutting tool
Never work on a smooth, slippery hill or slope
Never use the machine in the vicinity of highly
After contact with a foreign object:
Switch off the engine.
Check the machine for damage.
People who are not familiar with the trimmer should
practice handling it while the engine is turned off.
Original instructions for use