Manual Search; Clear Service List (*); First Time Installation - Telefunken TF3236HX880LU Mode D'emploi

Set Language item by pressing the " " or " "
buttons. Press the " " or " " buttons to highlight
the Country item and then use " " or " " to set.
Press the " " or " " buttons to highlight TXT
Language. Select a region by using the " " or "
" buttons. When fi nished, press the OK or RED
button to continue. To cancel, press the BLUE
button.
After APS is fi nhalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers and
names assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them
via Program Table. See "Program Table"
section.
All channels found are stored in a sorted form
with respect to their channel numbers. Some
services may not appear with the correct channel
number. This is because some broadcasters
have no channel number information.

Manual Search

In Manual Search, the number of the multiplex
is entered manually and only that multiplex
is searched for the channels. For every valid
channel number, signal level and signal quality
are shown on the screen.
In both manual and auto search any existing
channel in the database is not re-stored to avoid
redundant duplicates of that channel.

Clear Service List (*)

(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
A02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32880W_1810UK_10065239-50156446.indd 30 A02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32880W_1810UK_10065239-50156446.indd 30
Use this setting to clear channels stored. Press
the " " or " " buttons to select Clear Service
List and then press OK. The following OSD will
be displayed on the screen:
Press OK to cancel.
Select Yes by pressing the " " or " " buttons
and press OK to delete all of the channels.

First Time Installation

The user can use this item to load default
settings, which were loaded to the receiver at
the factory.
To install factory settings, highlight the "First
Time Installation" menu item and press the
OK button, then you will be asked whether or
not to delete the settings. Selecting "Yes" and
pressing the OK button will delete the existing
channel table.
After factory settings are loaded, the "First Time
Installation" menu will be displayed.
The menu which is displayed for language
selection appears on the screen at fi rst. By
using the " " or " " buttons, select the desired
language option, and press the OK button to
activate.
After then, the "First time installation" OSD
will appear on the screen. By pressing the "
" or " " buttons, select the country you want to
set and press the OK button.
Note: Country selection will not be available for UK.
Press OK to continue.
After the country (for EU countries) is selected,
a message asking for automatic search appears
on the screen:
English - 81 -
26.09.2009 17:00:34 26.09.2009 17:00:34