Initial Settings - Telefunken TF3236HX880LU Mode D'emploi

Initial Settings

When the TV set is operated for the fi rst time,
the IDTV turns on fi rst. Because this is the fi rst
time that the IDTV has been used, there are no
channels stored in the memory.
When the TV is turned on for the fi rst time, the
menu for the language selection appears on the
screen. The message "Welcome please select
your language!" is displayed in all language
options sequentially in the OSD.
By pressing the " " or " " buttons highlight
the language you want to set and press the
OK button.
You can get information about the menu usage
by pressing the INFO button. Press the INFO
button again to exit the help menu.
After then, the "First time installation" OSD
will appear on the screen. By pressing the " "
or " " buttons, select the country you want to
set and press the OK button.
Note: Country selection will not be available for UK.
Press OK to continue.
After then, the active antenna selection OSD
appears on the screen:
By pressing " " or " " buttons, set active
antenna mode as on or off.
If an active antenna is connected to your TV,
you can select this option as On. Antenna
power should be "Off" when standard antenna
is used instead of the active antenna. See
Confi guration Menu in the following sections
for more information.
Press OK button on the remote control to
continue and the following message will be
displayed on the screen:
A02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32880W_1810UK_10065239-50156446.indd 20 A02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32880W_1810UK_10065239-50156446.indd 20
• To start automatic search, select "Yes", to
cancel select "No".
• To select one of the "Yes" or "No" options,
highlight the item by using the " " or " "
buttons and press OK button.
The IDTV will automatically tune to the
transmission channels, searching for digital
terrestrial TV broadcasts and displaying the
names of channels found. This process will take
about fi ve minutes. To cancel searching, you
can press the M button at any time during the
process. The following OSD will be displayed
during the automatic search:
After Automatic Search is completed, the
following message asking for analogue channel
search appears on the screen. The TV switches
to the analogue TV mode.
To search for analogue channels, select "Yes".
The following menu will be displayed to search
for analogue channels:
Set Language item by pressing the " " or " "
buttons. Press the " " or " " buttons to highlight
a Country item and then use " " or " " to set.
Press the " " or " " buttons to highlight TXT.
Language. Select TXT Language by using the
" " or " " buttons. To cancel, press the BLUE
English - 71 -
26.09.2009 17:00:29 26.09.2009 17:00:29