Favourite Mode; Scan Encrypted (**); Channel List; Active Antenna - Telefunken TF3236HX880LU Mode D'emploi

The
(*) Hard of Hearing function will not be available
for UK.

Favourite Mode

This function enables or disables the 5 favourite
channel list mode by pressing the " " or "
" buttons and OK. If a favourites list exists, it
will switch to the list number selected. If there
is no favourite listing, a warning message will
be displayed.

Scan Encrypted (**)

After performing first time installation, the Scan
Encrypted Channel feature will always be set
as ON.
When this setting is ON, the search process
will locate the encrypted channels as well. If it
is set as OFF, encrypted channels will not be
located neither during automatic search nor
manual search.
Use the " " or " " buttons to select Scan
Encrypted and then press the " " or " " buttons
to set this setting as Yes or No.
(**) For UK only

Channel List

Use the " " or " " buttons to go to the Channel
List option. Use " " or " " buttons to toggle
Channel List Mode. If you select "TV Only", with
the " " or " " buttons, you navigate through only
TV channels. If you select "Radio Only", with
the " " or " " buttons, you navigate through
only radio channels. If you select "Text Only",
with the " " or " " buttons, you navigate through
only text channels. If you choose "Show All", all
channels can be navigated. To save the recent
changes and exit; press the M button.

Active Antenna

Use " " or " " buttons to highlight Active
Antenna option.
When antenna power option is set as On
by pressing " " or " " button, +5V will be
transmitted to the antenna output.
This feature enables the use of active
antenna.
Note: Antenna power should be "Off" when standard
antenna is used instead of the active antenna.
A02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32880W_1810UK_10065239-50156446.indd 27 A02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32880W_1810UK_10065239-50156446.indd 27

Receiver Upgrade

Over Air Download (OAD)

To ensure that your TV always has the most
updated information, use this setting. Please
ensure that the TV is set to standby mode. The
TV automatically powers up at 3.00 A.M. each
day and searches for any new information ,
which may be broadcasted and will download
this to your receiver automatically. This operation
will normally take approximately 30 minutes. If
you have an important recording to be carried
out at 3.00 A.M. and you do not want to interrupt
it, disable auto OAD search by performing the
following:
• Press the M button and use the " " or " "
buttons to choose Setup and press the OK
button.
• Highlight Confi guration menu the with " " or
" " keys and press OK.
• Use the " " or " " buttons to choose
"RECEIVER UPGRADE" and press the OK
button.
• Using the " " or " " buttons change "Automatic
scanning" from Enabled to Disabled.
• Highlight "Scan for upgrade" menu with the
" " or " "keys and pres OK to commence
upgrade.
• After the search progress is completed, the
message " Completed searching for upgrade.
No new software was found" appears on the
screen if no new software is found.

Parental Control

• Some channels broadcast material which you
do not want younger members of the family
to watch. Any channel can be 'locked' so that
it cannot be selected for viewing unless a
four-digit PIN code is entered. In this way any
English - 78 -
26.09.2009 17:00:32 26.09.2009 17:00:32