Christopeit Sport WP 1500 Notice De Montage Et D'utilisation page 14

STEP 4:
Refill the water tank (16).
1. Use tap water from a bucket to refill water tanks
(16). Remove the filling plug (17) from the water
tank, insert the flexible pipe end of the water pump
(89) approx. 10 cm into the water tank (16) and the
rigid pipe end into the bucket with water.
2. Turn on the screw cap and press the hand bel-
lows to pump the water into the tank (16). (If the
bucket position is higher than the tank the water will
flow automatically into the tank after pressing some
hand bellows. Turn off the screw cap to interrupt the
waterflow.) The tank has a mark for the max. wa-
ter level. This maximum limit may not be exceeded.
Caution: If the tank (16) is overfilled, water will spill
out during transport and during training and may
cause damage.
3. We recommend refill the water level slightly be-
low max. level, as this is the optimal rowing resist-
ance given. The desired intensity during training
is freely selectable by the speed of the rowing. For
less water resistance you can remove water from the
tank by means of the hand pump (89) by swapping
the pipe ends of the hand pump.
STEP 5:
Fold up and storage the rowing machine.
1. To storage the rowing machine, screw out the
hand grip screw (68) totally and pull the locking pin
(70) to unlock the seat rail (69). Fold up the seat rail
(69) into vertically position and secure this position
with push in the locking pin (70) in the holes which
align. The hand grip screw (68) and washer (103) you
can storage into the thread at bottom area of frame
(52).
STEP 6:
Checks
1. Check the correct installation and function of all
screwed and plug connections. Installation is thereby
complete.
2. When everything is in order, familiarize yourself
with the machine at a low exercise.
Note:
Please keep the tool set and the instructions in a safe
place as these may be required for repairs or spare
parts orders becoming necessary later.
14
GB