FAR LV15C42RD21S Mode D'emploi page 92

ENGLISH
Setting
The amount of salt dispensed can be set from
H0 to H7.
Salt is not required at the set value H0.
1. Find out about the hardness value of your tap
water. Your water utility company will help
you with this.
2. Set value can be found in the water hardness
table.
3. Close the door.
4. Switch on « Power » switch.
5. Hold down « Delay » button and press
« Program » button for 5 seconds. The buzzer
rings one time and H.
6. Flashes on the digital display.(factory setting
is H4)
For optional
GB-14