Publicité
Les langues disponibles
Les langues disponibles
Once the appliance has been installed, the
power supply cable and the electrical socket
should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it
must be replaced by the manufacturer or
its Technical Assistance Service in order to
prevent all potential hazards.(See Assistance)
The company shall not be held responsible for
any incidents that occur if these regulations
are not observed.
Advice regarding the first wash cycle
After the appliance has been installed,
immediately before running the first wash cycle,
completely fill the salt dispenser with and add
approximately 2 Kg of salt (see Rinse aid and
refined salt). The water may overflow: this is
normal and is not a cause for concern. It is also
normal that the LOW SALT indicator light
continues to flash for a few cycles after the salt
has been loaded.
ENGLISH
GB-59
Publicité
